No Set Tag - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Call up the command with the following parameters:

set tag <value(1-0xffffff)>

The parameter has the following meaning:

The routing information is forwarded with a changed tag.

Further notes

You delete the setting that the tag of the routing information is changed with the

You change to the Route maps configuration mode with the command

You display the setting and other information with the

no set tag

With this command, you delete the setting that the tag of the routing information is changed.

This command is available only with layer 3.

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Value of the tag

Range of values / note

1 ... 0xffffff

Enter the new value for the tag with which the routing infor-

mation will be forwarded.

You can enter the value in decimal or hexadecimal.

show route-map

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11