Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf priority <priority>
The parameter has the following meaning:
Parameter
priority
Result
The priority is specified.
Further notes
You enable OSPFv3 routing with the
You reset the priority to the default with the
You display the configuration with the
9.3.4.12
no ipv6 ospf priority
Description
With this command, you reset the router priority back to the default value.
Note
This command is available only with layer 3.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Priority
ipv6 router ospf
Range of values / note
0 ... 255
Default: 1
command.
no ipv6 ospf priority
show ipv6 ospf interface
Layer 3 functions
9.3 OSPFv3 (IPv6)
command.
command.
611