No Ip Dhcp Config-File-Request - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call the command without parameters:
ip dhcp config-file-request
Result
The DHCP config file request option is enabled.
Further notes
You disable the DHCP config file request option with the
command.
7.3.2.2

no ip dhcp config-file-request

Description
With this command, you disable the DHCP config file request option.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip dhcp config-file-request
Result
The DHCP config file request option is disabled.
Further notes
You enable the DHCP config file request option with the
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Network protocols
7.3 DHCPv4 client (IPv4)
no ip dhcp config-file-request
ip dhcp config-file-request
333