No Ip Dhcp-Server Pool; Commands In The Dhcppool Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.5 DHCP server
7.5.2.6

no ip dhcp-server pool

Description
With this command, you delete the required IPv4 address band.
Requirement
● The IPv4 address band is not enabled.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip dhcp-server pool <pool-id (1-24)>
The parameter has the following meaning:
Parameter
pool-id
Result
The required IPv4 address band is deleted.
Further notes
You create an IPv4 address band with the
7.5.3

Commands in the DHCPPOOL configuration mode

This section describes commands that you can call up in the DHCPPOOL Configuration
mode.
In the Global Configuration mode, enter the
mode.
● If you exit the DHCPPOOL Configuration mode with the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the
Privileged EXEC mode.
352
Description
ID of the addressed IPv4 address band
Range of values / note
1 ... 24
command.
ip dhcp-server pool
command to change to this
ip dhcp-server pool
command, you return to the
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11