No Switchport Private-Vlan Host-Association; Switchport Private-Vlan Mapping - Siemens SCALANCE XM-400 Configuration Manual

6.1.3.17

no switchport private-vlan host-association

Description
With this command, you delete the configuration of a host port.
Requirement
● The interface is configured as a host port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no switchport private-vlan host-association
Result
The configuration is deleted.
Further notes
You configure a host port with the
You display this setting and other information with the commands
show vlan
You configure the interface as a host port with the command.
6.1.3.18

switchport private-vlan mapping

Description
With this command, you configure a promiscuous port.
The following settings are made:
● The interface becomes an untagged member of the primary PVLAN and all secondary
PVLANs.
● With incoming untagged frames, the port VLAN-ID of the primary VLAN is set.
● Ingress filtering is enabled.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
and
show vlan private-vlan
switchport private-vlan host-association
.
Network structures
6.1 VLAN
command.
,
show vlan port config
213