No Network Area - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
network <network number> area <area-id>
The parameters have the following meaning:
Parameter
network number
area-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The OSPF interface is configured.
Further notes
You remove the OSPF interface and the area with the
You can display the status of this function and other information with the
interface
9.2.3.18

no network area

Description
With this command, you remove the OSPF interface and the Area ID connected to the OSPF
interface.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
IP interface that will be used by OSPF.
Area-ID
command.
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
Enter the IP address of the inter-
face for which OSPF will be ena-
bled.
specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
command.
no network area
show ip ospf
541