Network structures
6.3 Spanning Tree
Syntax
Call the command without parameters:
no spanning-tree
Result
The spanning tree function is disabled.
Further notes
You enable the spanning tree function with the
You can display the status of this function and other information with the
detail
You can display information about active ports with the
command.
6.3.4.3
spanning-tree compatibility
Description
With this command, you configure the compatibility version of the protocol that will be used
by the spanning tree function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree compatibility {stp|rst|mst}
The parameters have the following meaning:
Parameter
stp
rst
mst
246
command.
Description
The version is compatible with the
Spanning Tree protocol
The version is compatible with the
Rapic Spanning Tree protocol
The version is compatible with the
Multiple Spanning Tree protocol
command.
spanning-tree
show spanning-tree active
Range of values / note
-
Default: enabled
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show spanning-tree