Vrrp Vrid-Track - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You enable the setting with the
You display the status of this function and other information in Privileged EXEC mode with
the
9.4.3.9

vrrp vrid-track

Description
With this command, you enable VRID tracking.
When enabled, all interfaces of a VRID are monitored. When the link of an interface changes
from "up" to "down", the priority of all VRRP interfaces with the same VRID is reduced to the
value "0".
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call the command without parameter assignment:
vrrp vrid-track
Result
VRID tracking is enabled.
Further notes
You disable VRID tracking with the
You display configured VRID trackings with the command
interface - vrid
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show vrrp
with the parameter
command.
vrrp virtual-ping
no vrrp vrid-track
.
detail
Layer 3 functions
9.4 VRRPv2 (IPv4)
command.
show vrrp interface
or
show vrrp
629