Syntax
Call the command without parameters:
no shutdown
Result
The Interface is activated.
Further notes
You deactivate the interface with the
You can display the status of this function and other information with the
interfaces
3.1.13.19
speed
Description
With this command, you configure the transmission speed of an interface.
The transmission speed can only be configured for electrical data transfer. On optical
connections, the transmission speed is fixed.
Requirement
● Autonegotiation is disabled.
● You are in the Interface configuration mode of an electrical interface.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
speed {10|100|1000}
The parameters have the following meaning:
Parameter
10
100
1000
Result
The transmission speed of the interface is configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
Description
Transmission speed 10 Mbps
Transmission speed 100 Mbps
Transmission speed 1000 Mbps
command.
shutdown
Configuration
3.1 System
show
105