Distribute-List Route-Map; No Distribute-List Route-Map - Siemens SCALANCE XM-400 Configuration Manual

9.7.3.5

distribute-list route-map

Description
This command enables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
distribute-list route-map <name(20)> {in | out}
The parameters have the following meaning:
Parameter
name
in
out
Result
The filtering is enabled.
9.7.3.6

no distribute-list route-map

Description
This command disables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Name of the routing table.
Incoming routing information is filtered.
Outgoing routing information is filtered.
Layer 3 functions
9.7 RIPng (IPv6)
Range of values / note
Maximum of 20 characters.
-
-
701