Commands In The Global Configuration Mode; Ipv6 Dhcp Relay Remote-Id - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.7 DHCPv6 Relay Agent (IPv6)
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not specify any parameters, the counter is reset on all interfaces.
Result
The counters are reset.
Further notes
You enable the DHCPv6 relay agent with the
You display the information with the
7.7.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.7.3.1

ipv6 dhcp relay remote-id

Description
With this command, you specify whether the DHCP relay agent option 37 (Remote ID) is
used.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp relay remote-id {enable | disable}
378
ipv6 dhcp relay.
show ipv6 dhcp relay information
command to change to this mode.
configure terminal
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
command and are then in the