9.3.4.4
no ipv6 ospf dead-interval
Description
With this command, you reset the interval to the default value.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf dead-interval
Result
The interval is reset.
Further notes
You enable OSPFv3 routing with the
You configure the interval with the
You display the configuration with the
9.3.4.5
ipv6 ospf hello-interval
Description
With his command, you specify the interval between two Hello packets.
Note
This command is available only with layer 3.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
ipv6 router ospf
no ipv6 ospf dead-interval
show ip ospf interface
Layer 3 functions
9.3 OSPFv3 (IPv6)
command.
command.
605