Network structures
6.1 VLAN
● Frames tagged with the VLAN ID of the transparent VLAN and that are received at these
ports are forwarded to all transparent ports once again tagged with the VLAN ID of the
transparent VLAN.
● Other frames are forwarded according to the normal VLAN rules and a transparent port
behaves like an untagged member in this VLAN.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameters:
transparent-vlan
Result
The VLAN is changed to transparent mode.
Further notes
● All ports that were not members or untagged members in the relevant VLAN are
automatically set to the Forbidden status after the command executes.
● As long as a VLAN is configured as a transparent VLAN, the ports belonging to this VLAN
cannot be modified.
● Note that only one VLAN can be configured as a transparent VLAN.
You disable the setting with the
6.1.4.10
no transparent-vlan
Description
With this command, you return a VLAN from the transparent mode to the mode conforming
with the standard.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
226
command.
no transparent-vlan
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11