Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ip nat
Result
NAT is activated for the IP interface.
Further notes
You disable NAT for the selected IP interface with the
You display the current configuration with the
9.9.3.2
no ip nat
Description
With this command, you disable NAT for the selected IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip nat
Result
NAT is deactivated for the selected IP interface.
Further notes
You enable NAT for the selected IP interface with the
You display the current configuration with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
no ip nat
command.
show ip nat summary
command.
ip nat
command.
show ip nat summary
Layer 3 functions
9.9 NAT (IPv4)
743