Network structures
6.1 VLAN
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
subnet-vlan
Result
The classification is enabled.
Further notes
You disable the setting with the
You can display the status of this function and other information with the
info
You configure IPv4 subnet-based VLAN with the
6.1.2.8
no subnet-vlan
Description
With this command, you disable IPv4 subnet-based VLAN on all interfaces.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no subnet-vlan
Result
The setting is disabled.
196
command.
command.
no subnet-vlan
map subnet
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show vlan device
command.