Siemens SCALANCE XM-400 Configuration Manual page 525

Requirement
● The router is an area border router
● You are in the OSPF Router configuration mode.
The command prompt is:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <AreaId> range
<Network>
<Mask>
[{
advertise | notadvertise
}]
The parameters have the following meaning:
Parameter
AreaId
Network
Mask
advertise
notadvertise
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is configured.
Further notes
You delete the address range with the
You can display the status of this function and other information with the
area-range / summary-address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Area-ID
IP address of the address range
Subnet mask of the address range
The address range is advertised to the
outside. A summary LSA of Type 3 is
generated.
The address range is not advertised to
the outside.
no area range
command.
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
specify the IP address
specify the subnet mask.
-
-
command.
show ip ospf -
525