Commands In The Global Configuration Mode; Loopd - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
port-channel
port-channel-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The loop interface is displayed.
Further notes
You can display the status of this function and other information with the
command.
12.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
12.3.2.1

loopd

Description
With this command, you enable the loop detection function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a port channel connection
Number of the addressed port channel
configure terminal
Range of values / note
-
Enter a valid interface.
-
1 ... 8
command to change to this mode.
or command and are then in the
end exit
Diagnostics
12.3 Loop detection
show loopd
913