Redistribute - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(20)> {in | out}
The parameters have the following meaning:
Parameter
name
in
out
Result
The filtering is disabled.
9.7.3.7

redistribute

Description
With this command you specify which route information is forwarded by RIP.
Note
This command is available only with layer 3.
Requirement
You are in the RIP router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
redistribute {static|connected|ospf} metric <integer(0-16)> [route-map <name(20)>]
The parameters have the following meaning:
Parameter
default
connected
702
Description
Name of the routing table.
The filtering for incoming routing infor-
mation is disabled.
The filtering for outgoing routing infor-
mation is disabled.
Description
Default routes are distributed.
Route information of local subnets (IP
interfaces) is distributed for which RIP
is not configured.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Maximum of 20 characters.
-
-
Range of values / note
-
-
Configuration Manual, 06/2016, C79000-G8976-C252-11