Layer 2 management protocols
8.7 Multicast
8.7.2.3
no mac-address-table static multicast
Description
With this command, you delete a static multicast address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static multicast <aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:a
a:aa
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The "static multicast" function is disabled.
496
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Range of values / note
-
-
1 ... 4094
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11