9.5.5.6
no vrrp compatible-mode
Description
With this command, you disable compatibility with VRRPv2. The VRRP router can only send
and receive VRRP packets of version 3.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> compatible-mode
The parameter has the following meaning:
Parameter
vrid
Result
The compatibility is disabled.
Further notes
You configure a VRRP3 interface with the
You assign IPv4 / IPv6 addresses to a virtual router with the
You enable the compatibility with the
You can display the status of the function with the
interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
ID of the virtual router
command.
command.
interface
command.
vrrp compatible-mode
show vrrp3
Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
Range of values / note
1 ... 255
command.
vrrp associated-ip
or with the
show vrrp3
665