Show Ipv6 Ospf Neighbor - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
The parameters have the following meaning:
Parameters
Vlan
vlan-id
interface-
type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the information is displayed for all
available interfaces.
Result
The Information of the OSPFv3 interface is displayed.
9.3.1.7

show ipv6 ospf neighbor

Description
This command shows information about the detected neighboring routers.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ipv6 ospf neighbor [ <Neighbor-RouterID> ]
The parameter has the following meaning:
Parameters
Neighbor-RouterID
If you do not enter a router ID, information on all neighbor routers that can be reached via
the link is shown.
572
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
Description
Router ID of the neighbor
Values
-
1 ... 4094
Enter a valid interface.
Values
Specify the ID
0 ... 64
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11