No Channel-Group - Siemens SCALANCE XM-400 Configuration Manual

Parameter
active
passive
Result
The Etherchannel is configured.
6.2.3.2

no channel-group

Description
With this command, you remove the interface from an Etherchannel.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no channel-group
Result
The interface is deleted from the Etherchannel.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
The negotiation of a connection via
LACP is started unconditionally
The negotiation of a connection via
LACP is started when an LACP packet
arrives from the connection partner
Network structures
6.3 Spanning Tree
Range of values / note
-
-
233