Ipv6 Address Dhcp - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
Further notes
You configure the IPv6 address with the
You display this setting and other information with the
7.2.4.3

ipv6 address dhcp

Description
With this command, you specify whether the DHCPv6 client obtains the (
DHCPv6 server or supports the function "prefix delegation" (
enabled, the DHCPv6 client becomes the PD router.
You can also change the prefix name. The requirement is that the prefix is not used by a PD
sub-client interface.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 address dhcp [stateful | pd <PD Name (128)>] [rapid-commit]
The parameters have the following meaning:
Parameter
stateful
pd
PD Name
rapid-commit
322
ipv6 address
Description
Obtains the IPv6 address from the DHCPv6
server
Keyword for IPv6 prefix delegation
The prefix name id further distributed by the
router
Can only be used with the
rameter.
Reduces the procedure of 4 DHCPv6 mes-
sages (SOLICIT, ADVERTISE , REQUEST,
REPLY) to 2 DHCPv6 messages (SOLICIT,
REPLY).
This is only possible when the DHCPv6
server supports this.
command.
show ipv6 interface
). When this function is
pd
Range of values / note
-
-
Enter the prefix name.
128 characters
pa- -
stateful
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
) from the
stateful