Network protocols
7.2 IPv6 protocol
Result
The interface ID is configured.
Further notes
You delete the interface ID with the
You display this setting and other information with the
7.2.4.10
no ipv6 interface-identifier
Description
With this command, you delete the interface ID.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 interface-identifier <prefix>
The parameter has the following meaning:
Parameter
prefix
Result
The interface ID has been deleted.
Further notes
You configure the interface ID with the
You display this setting and other information with the
328
no ipv6 interface-identifier
Description
Interface ID
ipv6 interface-identifier
command.
show running-config
Range of values / note
Enter an interface ID.
command.
show running-config
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.