Layer 3 functions
9.4 VRRPv2 (IPv4)
9.4.4.4
vrrp preempt
Description
With this command, you specify that a router with higher priority can take over the master
role from a router with lower priority.
Note
This command is available only with layer 3.
Requirement
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> preempt [delay minimum <value(0-30)>]
The parameters have the following meaning:
Parameter
vrid
delay minimum
value
Result
The function is enabled.
Further notes
You enable routing with VRRP with the
You disable the function with the
You can display the status of the function with the
show vrrp interface
634
Description
ID of the virtual router
Keyword for a period of time
Time after which the new Master router
sends its VRRP packet.
router vrrp
no vrrp preempt
command.
Range of values / note
1 ... 255
-
0 ... 30
command.
command.
show vrrp interface - vrid
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or with the