No Ip Igmp Snooping Port-Purge-Interval; Commands In The Vlan Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.3 IGMP snooping
8.3.2.7

no ip igmp snooping port-purge-interval

Description
With this command, you reset the setting for the purge time to the default value.
The default value is 260 seconds.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip igmp snooping port-purge-interval
Result
The purge time is reset to the default value.
Further notes
You configure the setting with the
You can display the status of this function and other information with the
snooping globals
8.3.3

Commands in the VLAN configuration mode

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
When doing this, you need to replace the
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
Configuration mode.
● If you exit the VLAN Configuration mode with the
Privileged EXEC mode.
466
ip igmp snooping port-purge-interval
command.
command to change to this mode.
vlan $$$
placeholders with the relevant VLAN ID.
$$$
command, you return to the Global
exit
command, you return to the
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show ip igmp