Diagnostics
12.3 Loop detection
Syntax
Call the command without parameters:
loopd
Result
The loop detection function is enabled
Further notes
You disable the function with the
You can display the status of this function and other information with the
command.
12.3.2.2
no loopd
Description
With this command, you disable the loop detection function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no loopd
Result
The loop detection function is disabled
Further notes
You enable the function with the
You can display the status of this function and other information with the
command.
914
command.
no loopd
command.
loopd
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show loopd
show loopd