Permit Tcp - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.4 IP access control list
Parameter
src-ip-address
src-ip-address
src-mask
any
host
dest-ip-address
dest-ip-address
dest-mask
message-type
type
message-code
code
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP access list for ICMP messages has been configured.
Note
Subnet mask for individual hosts
If you create the rule for a single system (one IPv4 address), specify the subnet mask
"255.255.255.255". As an alternative, you can specify the keyword "host" followed by the
IPv4 address.
Further notes
You delete an IP access control list with the
command.
You display the configuration of the access control list with the
11.4.4.5

permit tcp

Description
With this command, you configure an IP access control list for the TCP protocol.
You have the following options:
● All incoming and/or outgoing TCP segments are forwarded.
● Incoming and/or outgoing TCP segments of a specific host are forwarded.
846
Description
Source IPv4 address
Network source address
Corresponding subnet mask
Blocks all outgoing frames
Keyword for a an individual IPv4 ad-
dress
Destination IPv4 address
Network destination address
Corresponding subnet mask
Keyword for the ICMP message type
ICMP message type
Keyword for the ICMP message code
ICMP message code
no ip access-list standard <acl-num>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
Enter a valid IPv4 address.
Enter a valid combination of IPv4
address and subnet mask.
-
-
Enter a valid IPv4 address.
Enter a valid combination of IPv4
address and subnet mask.
-
0 ... 255
-
0 ... 255
show access-lists
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.