Syntax
Call up the command with the following parameters:
ip nat {idle timeout <seconds (60-86400)> | {tcp | udp } timeout <seconds (300-
86400)>}
The parameters have the following meaning:
Parameter
idle timeout
seconds
tcp
udp
Result
The time periods are defined.
Further notes
You can reset the time periods to the default with the
You display the current configuration with the command.
9.9.2.4
no ip nat timeout
Description
With this command you reset periods of time after which existing connections are deleted
back to the default value.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Keyword for the time after which a xxxx
connection is deleted
Value for the time in seconds
Keyword for the time after which a TCP
connection is deleted
Keyword for the time after which a UDP
connection is deleted
Layer 3 functions
Range of values / note
-
For the parameter
60 ... 86400
•
For the parameter
300 ... 86400
•
-
-
command.
ip nat timeout
9.9 NAT (IPv4)
:
idle
:
udp
741