No Ip Dhcp-Server Icmp-Probe; Ip Dhcp-Server Pool - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.5 DHCP server
Result
The function is enabled.
Further notes
You disable the function with the
7.5.2.4

no ip dhcp-server icmp-probe

Description
With this command you disable the function "Probe address with ICMP echo before offer".
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server icmp-probe
Result
The function is disabled.
Further notes
You enable the function with the
7.5.2.5

ip dhcp-server pool

Description
With this command, you have three options of changing to the DHCPPOOL configuration
mode and to assign an interface to the IPv4 address band.
1. If you call the command
change to the corresponding DHCPPOOL configuration mode. The corresponding pool
ID must have already been created.
2. If you call the
type/interface-id
350
no ip dhcp-server icmp-probe
ip dhcp-server icmp-probe
ip dhcp-server pool
command with the parameter
ip dhcp-server pool
, an IPv4 address band with the next free pool ID is created and the
command.
command.
with the parameter
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
, you
pool-id (1-24)
or
vlan interface-