No Match Next-Hop Ipv6 - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

no match next-hop ipv6

With this command, you delete the filter for the next router (IPv6).

This command is available only with layer 3 (IPv6).

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Call up the command with the following parameters:

no match next-hop ipv6 <next hop IPv6 address>

The parameter has the following meaning:

next-hop Ipv6 ad-

The filter for the next router (IPv6) is deleted.

Further notes

You create a filter for the next router (IPv6) with the

You create a filter for the next router (IPv4) with the

You change to the Route maps configuration mode with the command

You display the setting and other information with the

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

IPv6 address

Range of values / note

Enter the IPv6 address of the router to which the routing infor-

mation will be sent next.

match next-hop ipv6

match next-hop ip

show route-map

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)