Syntax
Call up the command with the following parameters:
no ip ospf message-digest-key <Key-ID (0-255)>
The parameter has the following meaning:
Parameter
Key-ID
Result
The password is deleted.
Further notes
You specify the password with the
9.2.4.13
ip ospf retransmit-interval
Description
With this command, you specify the time after which an LSA message is transferred again if
no confirmation has been received.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf retransmit-interval <seconds (0 - 3600)>
The parameter has the following meaning:
Parameter
seconds
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
ID of the password
ip ospf message-digest-key
Description
Interval in seconds
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
Enter a valid ID.
command.
Range of values / note
0 - 3600
561