Standby Wait-For-Partner - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 2 management protocols

8.5 Ring redundancy and standby connection

The parameters have the following meaning:

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The ports for a standby connection are disabled.

Further notes

You enable the setting with the

You can display the status of this function and other information with the

standby wait-for-partner

With this command, you enable the "Wait for standby partner" function on the device. A

standby connection is enabled only after the standby master and the standby slave as well

as their standby partners have established a connection. This ensures that the redundant

connection is really available before communication via a standby connection is enabled. As

default, this function is enabled.

You are in the Redundancy configuration mode.

The command prompt is as follows:

cli(config-red)#

Call the command without parameters:

standby wait-for-partner

The "Wait for standby partner" function is enabled.

Type or speed of the interface

Module no. and port no. of the interface

standby port

Range of values / note

Enter a valid interface.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11