Network protocols
7.5 DHCP server
Further notes
You disable the ports with the
You display the setting with the
You enable the IPv4 address band with the
7.5.3.9
no ports
Description
With this command you disable the ports via which the IPv4 addresses of an address band
in the local subnet are assigned.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no ports [<interface-type> <0/a-b, 0/c, ...>] [<interface-type> <0/a-b, 0/c, ...>]
[all]
The parameters have the following meaning:
Parameter
interface-type
0/a-b,0/c,...
all
For information on identifiers of addresses and interfaces, refer to the section "Auto-
Hotspot".
Result
The selected ports will be disabled.
Further notes
You enable the ports with the
You display the setting with the
You enable the IPv4 address band with the
360
command.
no ports
show ip dhcp-server pools
pool-enable
Description
Type or speed of the interface
Port no. of the interface
All ports will be disabled.
command.
ports
show ip dhcp-server pools
pool-enable
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
command.
Range of values / note
Enter a valid interface
-
command.
command.
Configuration Manual, 06/2016, C79000-G8976-C252-11