Area Summary-Prefix - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
9.3.3.6

area summary-prefix

Description
With this command, you assign an area ID an address range. The address range is used to
group the external routes.
Note
This command is available only with layer 3.
Requirement
● The area is of the type NSSA
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
area <AreaID> summary-prefix
<IPv6-Prefix> <Prefix-Length>
[{
allowAll | denyAll | advertise | not-advertise
}]
[
Translation { enabled | disabled }
]
The parameters have the following meaning:
Parameter
AreaID
IPv6-Prefix
Prefix-Length
allowAll
denyAll
586
Description
Area ID
IPv6 address
Number of bits belonging to the prefix
(from left to right)
The backbone area generates an LSA message of
type 5 for the address range. LSA messages of
Type 7 also generated for this address range in the
connected NSSAs.
No LSA is of type 5 or type 7 is generated for the
address range.
Range of values / note
Specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
0.0.0.0 = backbone area
enter a valid IPv6 address
1 ... 128 bits
128: The node (host) itself
only with backbone area
only with backbone area
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11