Layer 3 functions
9.3 OSPFv3 (IPv6)
Result
The interval is reset.
Further notes
You enable OSPFv3 routing with the
You configure the interval with the
You display the configuration with the
9.3.4.15
ipv6 ospf transmit-delay
Description
With this command you specify the time that a link state update packet requires for
transmission.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Requirement
● Layer 3 interface
● The router ID is configured.
614
command.
ipv6 router ospf
ipv6 ospf retransmit-interval
show ipv6 ospf interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.