Ipv6 Mld Snooping - Siemens SCALANCE XM-400 Configuration Manual

Result
The limit is deleted.
Further notes
You define the max. number of Join-messages on the device with the
ratelimit
You can display the status of this function and other information with the
snooping globals
8.8.2.3

ipv6 mld snooping

Description
With this command, you enable MLD snooping on the device or on the required VLAN.
For MLD snooping to work, you need to enable the function globally and in the VLANs. In the
Global configuration mode, enable MLD snooping on the device or globally. To enable MLD
snooping on the required VLAN, execute the command in the VLAN configuration mode.
Requirement
● GMRP is disabled.
● You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 mld snooping
Result
MLD snooping is enabled.
Further notes
You disable GMRP with the
You disable MLD snooping with the
You display the setting and other information with the
mld snooping globals
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
command.
no grmp
commands.
command.
command.
no ipv6 mld snooping
show ipv6 mld snooping
Layer 2 management protocols
8.8 MLD Snooping (IPv6)
ipv6 mld join
show ipv6 mld
and
show ipv6
503