No Area Range - Siemens SCALANCE XM-400 Configuration Manual

Parameter
notadvertise
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is configured.
Further notes
You delete the address range with the
You can display the status of this function and other information with the
area-range / summary-address
9.2.3.5

no area range

Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <AreaId> range <Network> <Mask>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
The address range is not advertised to
the outside.
no area range
command.
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
-
command.
show ip ospf -
527