Syntax
Call the command without parameters:
no snmp engineid migrate
Result
The SNMPv3 user migration is disabled.
Further notes
You enable the SNMPv3 user migration with the
7.8.2.10
snmp group
Description
With this command, you configure the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp group <GroupName> user <UserName> security-model {v1|v2c|v3}
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
GroupName
user
UserName
security-model
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Name of the group
Keyword for the user name
Name of the user
specifies which security settings will be
used
snmp engineid migrate
Range of values / note
max. 32 characters
-
max. 32 characters
•
v1
•
v2c
•
v3
Network protocols
7.8 SNMP
command.
399