No Ipv6 Mld Join Ratelimit - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.8 MLD Snooping (IPv6)
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 mld join ratelimit <value(100-1000)>
The parameter has the following meaning:
Parameter
value
Result
The maximum number is defined.
Further notes
You delete das limit for Join-messages on the device with the
command.
You can display the status of this function and other information with the
snooping globals
8.8.2.2

no ipv6 mld join ratelimit

Description
With this command, you delete the limit for Join messages on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ipv6 mld join ratelimit
502
Description
Number of Join messages
command.
Range of values / note
100-1000
Default: 0
no ipv6 mld join ratelimit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show ipv6 mld