No Monitor Session Source - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.4 Port Mirroring
12.4.2.8

no monitor session source

Description
With this command, you delete the source for mirroring a port or a VLAN.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command for the port to be monitored with the following parameter assignment:
no monitor session<session-id(1-7)> source
{interface {<interface-type><interface-id> | port-channel <port-channel-id (1-8)>}
[{rx|tx|both}]}
or
Call up the command for the VLAN to be monitored with the following parameter assignment:
no monitor session <session-id (1-1)> source
{vlan <vlan-id> | mac-acl <acl-id>} | ip-acl <acl-id>}
The parameters have the following meaning:
Parameter
session-id
interface
interface-type
interface-id
port-channel
port-channel-id
rx
tx
both
vlan
vlan-id
mac-acl
932
Description
Number of the session
7 parallel sessions are possible only
with port-based mirroring and their
ports must not overlap.
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a port channel connection
Number of the addressed port channel
Received data traffic will be mirrored
(received)
Transmitted data traffic will be mirrored
(transmitted)
Received and sent data traffic will be
mirrored
Keyword for a VLAN connection
Number of the VLAN
Keyword for a MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 7
-
Enter a valid interface.
-
1 ... 8
-
-
-
-
1 ... 4094
-
Configuration Manual, 06/2016, C79000-G8976-C252-11