Switchport Acceptable-Frame-Type - Siemens SCALANCE XM-400 Configuration Manual

Result
The IP interface of the primary PVLAN cannot be reached from the selected secondary
PVLANs.
Further notes
You configure a link between secondary PVLANs and the IP interface of the primary PVLAN
with the command
You display this setting with the
parameter.
6.1.3.5

switchport acceptable-frame-type

Description
With this command, you configure which types of frames are accepted.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
The parameters have the following meaning:
Parameter
all
tagged
Result
The setting is enabled.
Further notes
You can reset the setting to the default with the
command.
You can display the status of this function and other information with the
config
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
private-vlan mapping
Description
All frames are accepted.
Note: On a ring port only the parameter
"all" is supported.
Untagged frames are discarded.
command.
.
command with the
show interfaces
no switchport acceptable-frame-type
Network structures
6.1 VLAN
private-vlan mapping
Range of values / note
Default:
all
-
show vlan port
203