Ip Igmp Query-Max-Response-Time - Siemens SCALANCE XM-400 Configuration Manual

Result
The interval is reset.
Further notes
You define the interval with the
You display the setting and other information with the
command.
8.2.3.13

ip igmp query-max-response-time

Description
With this command you specify the period of time in an IGMP query that the client has to
respond to a query.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp query-max-response-time <value (1-255) tenths of seconds>
The parameters have the following meaning:
Parameter
value
tenths of seconds
Result
The period of time is specified.
Further notes
You can reset the time to the default with the
command.
You display the setting and other information with the
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ip igmp query-interval
Description
Value for the time interval
Specified in tenths of seconds
no ip igmp query-max-response-time
Layer 2 management protocols
command.
show ip igmp global-config
Range of values / note
1 ... 255
Default: 100
-
show ip igmp global-config
8.2 IGMP
451