Commands In The Interface Configuration Mode; Loopd {Blocked | Forwarder | Sender - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.3 Loop detection
Result
The loop detection function is disabled for VLAN.
Further notes
You enable the function with the
You can display the status of this function and other information with the
command
12.3.3

Commands in the Interface Configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
12.3.3.1

loopd {blocked | forwarder | sender}

Description
With this command you specify how the port handles loop detection frames.
Requirement
● Loop detection is enabled
● A Spanning Tree port, ring port or standby port cannot be the sender port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
loopd {blocked | forwarder | sender}
916
command.
loopd vlan mode
command to change to this mode.
interface
exit
end
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
show loopd
command, you return to the
command, you return to the