Ipv6 Dhcp Relay Remote-Id Type - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.7 DHCPv6 Relay Agent (IPv6)
7.7.4.3

ipv6 dhcp relay remote-id type

Description
With this command, you specify the type of the remote ID.
Requirement
● The interface is an IPv6 interface.
● The DHCPv6 relay agent is enabled.
● The Remote ID is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp relay remote-id type {duid | system-name | mgmt-ip | userDefined}
The parameter has the following meaning:
Parameters
duid
system-name
mgmt-ip
userDefined
Result
The remote ID is specified.
Further notes
You enable the DHCPv6 relay agent with the
You enable the remote ID with the
You configure the interface as a router port with the
382
Description
Uses the DHCP unique identifier
You configure the entry with the
command.
mote-id duid
Uses the system name.
Uses the management IPv6 address
Uses a user-defined entry
You configure the entry with the
command.
mote-id userDefined
ipv6 dhcp relay remote-id.
ipv6 dhcp relay re-
ipv6 dhcp relay re-
command.
ipv6 address dhcp
command.
command.
no switchport
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
-
-
-
-