Area Nssa - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
The parameters have the following meaning:
Parameter
AreaId
Network
Mask
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is deleted.
Further notes
You create address ranges with the
9.2.3.6

area nssa

Description
With this command, you configure areas of the type NSSA (not-so-stubby-area).
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <area-id> nssa
[{
no-summary | default-information-originate
}]
528
Description
Area-ID
IP address of the address range
Subnet mask of the address range
area range
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
specify the IP address
specify the subnet mask.
command.
Configuration Manual, 06/2016, C79000-G8976-C252-11