Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip pim rp-set [rp-address]
The parameter has the following meaning:
Parameter
rp-address
Result
The multicast groups with rendezvous points belonging to them are displayed.
Further notes
You define interfaces as candidates for rendezvous points with the command
rp-address
You configure a device as a static rendezvous point with the
You specify the interfaces for static rendezvous points with the
command.
9.10.1.6
show ip pim bsr
Description
With this command, you display information on the selected bootstrap router (BSR).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip pim bsr
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
IP address of the interface
.
or
cli#
Layer 3 functions
9.10 PIM (IPv4)
Range of values / note
-
rp-candidate
command.
ip pim static-rp
rp-static rp-address
757