Layer 3 functions
9.7 RIPng (IPv6)
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ipv6 rip default-information
Result
The function is disabled.
Further notes
You enable IPv6 with the
You enable the function with the
9.7.4.3
ipv6 rip
Description
This command enables RIPng routing on the interface.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 rip
Result
RIPng routing is enabled.
706
command.
ipv6 enable
ipv6 rip default-information originate
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.