No Ip Access-Group - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.4 IP access control list
Result
The packets are filtered according to the access control list (ACL).
Further notes
You disable the setting with the
You display the configuration of the access control list with the
11.4.3.2

no ip access-group

Description
With this command, you disable the access control of the packets of an interface.
Requirement
You are in the Interface Configuration mode of a switch port, a router port or a VLAN.
The command prompt is as follows:
● With a switch port:
cli(config-if-Gi$-$)#
cli(config-if-Ex$-$)#
● With a router port
cli(config-RPort-Gi$-$)#
● With a VLAN
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip access-group [<access-list-number(1-128)>]{in|out}
The parameters have the following meaning:
Parameter
access-list-number
in
out
If you do not specify a number for an access control list, all lists of an interface are disabled.
838
no ip access-group
Description
Number of the access control list
Specifies that incoming packets are
filtered
Specifies that outgoing packets are
filtered
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
show access-lists
Range of values / note
1 ... 128
-
-
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.