Show Interface Mtu - Siemens SCALANCE XM-400 Configuration Manual

Result
The table of interface cards is displayed.
The slot ID, the status and the type or name of the card is listed.
3.1.1.8

show interface mtu

Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
outgoing management frames (egress).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interface mtu [{vlan<vlan-id(1-4094)>|
The parameters have the following meaning:
Parameter
vlan
vlan-id
port-channel
port-channel-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The settings for the MTU of the outgoing management frames are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
port-channel<port-channel-id(1-8)>|
<interface-type><interface-id>}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel
Type of interface
Module no. and port no. of the interface
Configuration
3.1 System
Range of values / note
-
1 ... 4094
-
1 ... 8
Enter a valid interface.
65